In December 1996, Team successfully designed, manufactured, and installed a one-ton leak-sealing enclosure on a 30" long radius 90 fitting for a central U.S. plant.

Service for the enclosure was a naphtha leak at approximately 30 psi.

The enclosure was designed and manufactured utilizing a 36" long radius 90 fitting as the basis for the enclosure. This method of design saved approximately 50% of the time normally required to manufacture the same enclosure by mitring pipe.

Void on the enclosure was 27,000 in³ before compression. Approximately one and one-half tons of sealant were used to successfully seal the customer's leak.

The customer thanked Team for the service and products.

For more information visit ISO 9001 Engineering, Design, and Manufacturing